'SandavaTS59CAJ' 59 x 29.5 inch Center Drain WARMED AIR JETTED High Gloss White ACRYLIC Freestanding Bathtub
Ready to plug in to a 15
amp - 110v GFCI
The 12 variable speed button head air jets on the floor of the tub allow thousands of bubbles to ripple up over you legs and body offering a truly relaxing bathing experience. These jets are activated using a waterproof handheld remote control and can be controlled from low to high speed..
While the blower does warm the bubbles, they can still feel a little cool when they roll over your body. This is simply the sensation they create, but the air inside the bubbles will actually be higher than the water temperature in the bath.
It can take the air bubbles up to a minute to warm, so activating the blower about 60-90 seconds before entering the bath is a good idea.
All of the air jet fittings are concealed between the inner and outer shells of the tub and need simply be connected to a 110v -15amp GFCI to be up and running.
To maintain hygiene in the air pipes, every time you take a bath and drain the water, engage the blower for about 15 seconds to purge all residual moisture in the lines. Every three to four months, we recommend that you fill the tub about two inches over the highest jet with lukewarm water and add a cup of bleach. Engage the blower and let run for two minutes. Empty and repeat this step with clean water and, after emptying, again activate the blower to remove any final moisture.