Home > Air Jetted Tubs >

SANSIRO 71 Inch 'Aquino-TS71CAJ' WARMED AIR JETTED Gloss White ACRYLIC Freestanding Bathtub Plus Integrated Drain
SanSiro 'AquinoTS71CAJ' 71 x 32 inch Center Drain HEATED AIR JETTED High Gloss White ACRYLIC Freestanding Bathtub
 
Alternative Views:


  • Includes a pop-up drain and overflow cover in choice of finish
  • 12 total button head air jets with backflow prevention in the tub floor
  • Waterproof handheld remote control operation
  • Ultra-Quiet variable speed warmed air blower
  • When the bubbles enter the water, even though they are warm, they will feel slightly cool to the skin
  • The air blower and all fittings are concealed within the tub shells
  • Designed and manufactured for optimal water heat retention
  • Requires ONE 110v - 15 amp GFCI electrical connection
  • MA Code Accepted
  • cUL Listed
PRODUCT MANUAL
SPECIFICATION SHEET
Price: $2,449.00


Free Shipping
Availability:: Ships in 1 to 2 weeks
Product Code: SSAAQ71TS


Modern Drain and Overflow Finish*:
Chrome (no extra)
Brushed Nickel (no extra)
Oil Rubbed Bronze (no extra)
Polished Nickel (no extra)
Brushed Brass (no extra)
Matte Black (no extra)

Description 5'8" Person in Tub
 
'AquinoTS71CAJ' 71 x 32 inch Center Drain WARMED AIR JETTED High Gloss White ACRYLIC Freestanding Bathtub

Ready to plug in to a 15 amp - 110v GFCI
The 12 variable speed button head air jets on the floor of the tub allow thousands of bubbles to ripple up over you legs and body offering a truly relaxing bathing experience. These jets are activated using a waterproof handheld remote control and can be controlled from low to high speed..
While the blower does warm the bubbles, they can still feel a little cool when they roll over your body. This is simply the sensation they create, but the air inside the bubbles will actually be higher than the water temperature in the bath.
It can take the air bubbles up to a minute to warm, so activating the blower about 60-90 seconds before entering the bath is a good idea.
All of the air jet fittings are concealed between the inner and outer shells of the tub and need simply be connected to a 110v -15amp GFCI to be up and running.
To maintain hygiene in the air pipes, every time you take a bath and drain the water, engage the blower for about 15 seconds to purge all residual moisture in the lines. Every three to four months, we recommend that you fill the tub about two inches over the highest jet with lukewarm water and add a cup of bleach. Engage the blower and let run for two minutes. Empty and repeat this step with clean water and, after emptying, again activate the blower to remove any final moisture.