'AquinoTS67CAJ' 67 x 32 inch Center Drain HEATED AIR JETTED High Gloss White ACRYLIC Freestanding Bathtub
Ready to plug in to a 15
amp - 110v GFCI
Made in the USA, the SanSiro
'TSAquino67CAJ' is a fabulous narrow lip minimalist heated air jetted acrylic
The adjustable speed air jets are activated
using a handheld remote control.
All of the air jet fittings are concealed
between the inner and outer shells of the tub and need simply be connected to a
110v -15amp GFCI to be up and running.
In the unlikely event of an issue with the
blower, access for repair is extremely simple. Unscrew the drain basket, lift
the tub straight up, turn it over on its' side and you have easy access to all
The tub requires either a wall mount or
freestanding tub filler.
No special drain is required and this package
includes everything needed to install the tub, including the drain.
There are 14 strategically positioned air
injectors to reach all areas of the legs, feet and back.
Bathers can enjoy a really soothing soft
We use what is considered to be the quietest
air blower on the market and when in the tub, you hear the bubbles, not the
To keep the injected air bubbles as warm as
possible, we equip the blower with a powerful heating element to pre-heat the
injected air. This heater will raise the ambient temperature 15 to 20 degrees
within a period of around 2 minutes, so switching the air jetting on before
entering the tub can be a good idea. While not feeling just as cold,
even heated air bubbles will feel a little cool when they make contact
with the skin.
To maintain hygiene in the air pipes, every time you take a bath and drain the
water, engage the blower for about 15 seconds to purge all residual water in
the lines. Every three months, we recommend that you fill the tub about two
inches over the highest jet with lukewarm water and add a half cup of bleach.
Engage the blower and let run for two minutes. Empty and repeat this step with
clean water and purge the lines when the tub is empty.
For additional strength, the tub shells are
specially fiberglass and resin coated and the air cavity in between the inner
and outer shells acts as a natural heat loss barrier. Independent tests with a
foam filled cavity indicate there is no improvement on heat retention.